Happymodel Larva-X HD 125mm F4 3S DSM2 / DSMX

EX1203 6200KV Motor	Configuration: 9N12P Stator Diamter: 12mm Stator Length:3mm Shaft Diameter: Φ1.5mm Motor Dimension(Dia.*Len): Φ15x5mm Weight: 4.7g No.of Cells: 2-3S Lipo
Crazybee F4FR PRO Flight Controller	Frsky SPI RX version: CRAZYBEE F4FR PRO V3.0 Firmware target: CrazybeeF4FR Flysky SPI RX version: CRAZYBEE F4FS PRO V3.0 Firmware target: CrazybeeF4FS External RX version: CRAZYBEE F4 PRO V3.0 Firmware target: CrazybeeF4DX MCU: STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board Size: 28.5x 28.5mm Power supply: 2-4S battery input (DC 7-17V) Built-in 10A(each) Blheli_S 4in1 ESC Dshot600 ready Could add external receiver on the FC board Built-in Betaflight OSD(SPI Control) Built-in Current meter Max 70A Current meter scale set to 470 Built-in 5V 1A BEC Built-in voltage detection
Onboard 12A 4in1 ESC	MCU upgraded to EFM8BB21 Power supply: 2-4S LiPo/LiPo HV (7v/17v) Current: 10A continuous peak 12A (5 seconds) Support BLHeliSuite programmable Factory firmware: F_H_40_REV16_7.HEX Default protocol: DSHOT600
Built-in Frsky SPI D8 Receiver Version	SPI BUS receiver Frsky D8 compatible Compatible Non EU transmitter D8 model Channels: 8ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m - Support add extral external receiver if you need
Built-in Flysky SPI Receiver Version	SPI BUS receiver Protocol: AFHDS and AFHDS-2A Switchable Channels: 8ch(AFHDS) or 14ch(AFHDS-2A) No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m Failsafe support - Support add extral external receiver if you need
External DSMX/DSM2 Receiver Version	Resolution: 1024/2048 Operating voltage: 3.3V Working current: 60MA Size: 18mm*13mm*5mm Antenna length: 30mm Protocol: DSM2/DSMX
External Frsky XM+ Receiver Version	Number of Channels: Up to 16CH from SBUS (1-15ch for PWM,16ch RSSI for FC) Operating Voltage Range: 3.7~10V Operating Range: Full range With RSSI output on board: Analog 0~3.3V Antenna: 10cm Firmware Upgradeable Compatibility: FrSky D16 mode
External Frsky RXSR Receiver Version	Weight: 1.5g Number of channels: 16CH (1-16CH from SBUS channel, 1~8CH from CPPM channel) Operating Voltage Range: 3.5V~10V Operating Current:70mA@5V Firmware Upgradable Compatibility: FrSky X Series modules and radios in D16 mode Could support Frsky New ACCST Protocol ( Upgrade firmware)
External TBS CRSF Nano Receiver Version	Original TBS CROSSFIRE Receiver , CRSF Protocol , Official TBS transmitter compatible
5.8G 40CH 25-200mW VTX	Output power: 25~200mw switchable Frequency: 40CH Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Antenna: Micro UXII Antenna Frequency: 5.8GHz 5bands 40 channels With Race band Smartaudio ready Weight: 3g
Caddx Baby Turtle Camera	TV system: NTSC/PAL changeable Video Resolution: 1080P@60fps / 1080P@30fps / 720@60fps Power Input: DC 4.5-20V Mini Illumination: 0.01lux Image Resolution: 2 Megapixels Working Current: 380mA@5V/160mA@12V (low consumption) OSD Menu: Yes (Support Voltage Display) Video Files: MP4 Audio: Support Electronic Shutter : PAL : 1/50-100,000 NTSC : 1/60-100,100 S/N Ratio: >60dB (AGC OFF) Video Output: CVBS
3S 11.4V 450mAh 75C Lipo Battery	Capacity:450mAh Voltage:11.4v Continuous Discharge Rate: 75C Size: 66mmx21mmx18mm Weight: 42g Connector: XT30

Features:

Package Included:
1x Larva X HD FPV Drone
2x 3S 11.1V 450mAh Lipo Battery
1x 5.8g Micro UXII Antenna
1x Propeller Disassemble Tool